The Remote Screen via Framebuffer allows you to see what is displayed on the screen of the edge device. This is helpful to monitor a user remotely.
Using this feature disables the Remote Screen to control.
What you will need
Make sure that you have prepared the following points:
- The edge device is set up with a TeamViewer Embedded Agent.
- Access the Edge Device via Remote Terminal.
Setup
1. Access the edge device remotely (Access the Edge Device via Remote Terminal).
2. To enable the Remote Screen type in the following command and press return.
sudo teamviewer-iot-agent configure set -p [int32] EnableRemoteScreen 1
3. Find the framebuffer number and write it down (see example below). Type in the following command and press return.
ls /dev/ | grep fb
4. Replace fb0 with the found framebuffer number. Restart the TeamViewer Embedded Agent. Type in the following commands and press return:
sudo teamviewer-iot-agent configure set -p [strng] RemoteScreenChannels "FBD:/dev/fb0" sudo teamviewer-iot-agent restart
The setup is complete. You can access the edge device with your TeamViewer Client now.
When accessing the edge device, the user who works on said device gets a notification. You can customize the notification.